387 products in our shop!
Our payment options

PayPal
SWIFT Bankkonto
IBAN Bankkonto
eCard

 

Out of stock!
Enter your email to be informed when this product arrives:


Send Close
Out of stock!
Enter your email to be informed when this product arrives:
Send Close

Super Spiral Turbo Ventilator, 71~78mm

In Stock
27.88 €
Tax Included!
Product Code: CT-726
Weight: 0.24kg

Super Spiral Turbo Ventilator, 71~78mm

Introduction

SIMOTA’s high speed SUPER SPIRAL creates a vortex air flow to improve air & fuel mixture enhancing your engine’s performance. It reduces the carbon accumulation in the engine and substantially increases the horsepower to your engine.

SUPER SPIRAL TURBO VENTILATOR blades are made of advanced precision bearing technology (running up to 30,000 RPM). Light weight aluminum alloy design is not only anti-rust, but also has the ability to match your high-revving engine. The blades have special angles to promote extra air flow to the inlet manifold and assist in providing better engine combustion. Experience strong torque during low to medium RPM ranges but also extreme horsepower at higher engine revolutions.

The upgraded fuel combustion can reduce carbon accumulation to your engine. Furthermore, it is environment friendly and greatly increases performance efficiency

Highlights

  • Improved fuel efficiency
  • Instant increase in engine power
  • Reduction in carbon accumulation in the engine
  • Minimized air pollution
  • Enhanced throttle response and acceleration
  • Easy to install
  • High precision Propeller Design
  • Aluminium Alloy Hull
  • Polished inner surface
  • 30,000 RPM Bearing System
  • Silicone Coupler

Instruction

  • Install the product between the air filter and the throttle body, into the middle of air inlet pipe.Propeller side face to the air filter.
  • Optimal location : Install the product 10 cm to 30 cm in front of the inlet throttle body.
  • When the inlet pipe is curved, you can install Super Spiral into the middle of dual bend pipe.
  • If the car is equipped with air flow sensors (AIF), install a Super Spiral before or after AIF with the same size. When there is minor difference in size, you can wrap a few rounds of tape on outer rim.
  • The products can be installed to gasoline & diesel cars, as long as there is the inlet pipe on the air inlet of the throttle.

 
Reference

Model Neck (MM)
CT-526 55~64mm
CT-626 65~70mm
CT-726 71~78mm

 

Car Brand Neck (MM)
Toyota 56~65mm(800C.C~2000C.C)
Mazda 71mm(over 2000C.C~)
Ford 56~71mm(800C.C~over 2000C.C)
Honda 71mm(over 2000C.C~)
Mitsubishi 70mm(over 2000C.C~)
Nissan 65mm(1300C.C~2000C.C)

 

Write a review

Your Name:


Your Review: Note: HTML is not translated!

Rating: Bad           Good

Enter the code in the box below: